We care about fasteners fastener everything, I believe that many users in the use of some with Phillips fasteners when there will be such a feeling that when using the Phillips, sometimes there will be slipping the case, then you know the reason why the skid Phillips do? Wire fasteners problem The firmware enterprise for production, when the use of fasteners, there will sometimes slip or wear is most likely is the fastener itself of the wire there is a problem, when we use a wire failure is likely to occur this problem usually enough lead wire in the hardness of the above, we can use some relatively high hardness of the wire will not appear on slip phenomenon. Now many of the mounting fasteners staff in order to improve efficiency, and are based on a number of electric screwdriver for installation, when using the process too fast, or excessive torque when slipping occurs Phillips or severe wear phenomenon . We can install a reasonable grasp of the process of electric screwdriver torque wrench or manually, so that the fastener can be fully guaranteed in the installation or removal of the process does not appear to slip phenomenon. When the fastener installed on some relatively high hardness object, there may be such a phenomenon Phillips slipping, if this is the reason, we can look at whether there is more and more examples of the situation, if it is, then we the heat treatment can be used fasteners, so to increase the hardness of fasteners, we can solve this problem.

　　 News From: shield, battery slice professional manufacturer in Dongguan Shengda Hardware Factory site: www.sd668.com